Filter
Top Products
N3G005W 3G Wireless Router User Guide YML894 Rev3
54 www.netcomm.com.au
Advanced Setting > SNMP
SNMP (Simple Network Management Protocol) is a protocol designed to give user the capability to remotely
manage a computer or network device by polling and setting terminal values and monitoring network events.
To Enable SNMP, you need to set the following:
• Enable SNMP. Check either Local or Remote or both to enable the function. If Local is ticked, the unit will
respond to request from LAN and if Remote is ticked, the unit will respond to request from WAN.
• Get Community. Set the community for GetRequest. This will act as a password.
• Set Community. Set the community for SetRequest. This will act as a password.
• IP 1,IP 2,IP 3,IP 4. Input the IP addresses of your management PCs. The unit will send SNMP Trap
message only to the IP address listed.
• SNMP Version. Select the SNMP version of your SNMP Management software.
Click Save to save the settings and Undo to cancel.