Filter
Top Products
YML894 Rev3 N3G005W 3G Wireless Router User GuideN3G005W 3G Wireless Router User Guide
www.netcomm.com.au 9
N3G005W
Restoring Factory Defaults
This feature will reset the Router to its factory default configuration. Occasions may present themselves where you
need to restore the factory default settings on your router. Typical situations are:
• You have lost your password and unable to login to the router;
• You have purchased the router from someone else and need to reconfigure the device.
• You are asked to perform a factory reset by a member of the excellent NetComm Support Staff.
In order to restore your router to its factory default settings, please follow these steps:
• Ensure that the router is powered on (for at least 20 seconds).
• Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the
reset is in progress. Do not power off the unit at this point.
• After the router reboots, the default settings are now restored. This entire process takes several minutes
to complete.
• Once you have reset the router to its default settings you will be able to access the device’s web
configuration using http://192.168.123.254 with password “admin”.
Default Settings
LAN (Management)
Static IP Address: 192.168.123.254
Subnet Mask: 255.255.255.0
Default Gateway: blank
WAN (Internet)
WAN mode: DHCP
Wireless
SSID: netcomm n3g series
Channel: Auto
Security: WEP, 64bit
WEP Key: a1b2c3d4e5
Modem Access
Username: admin
Password: admin