Filter
Top Products
NETGEAR 7000 Series Managed Switch Administration Guide
IP Routing Services 5-3
v1.1, May 2006
CLI Examples
This diagram shows a Layer 3 switch configured for port routing. It connects three different
subnets, each connected to a different port. The script shows the commands you would use to
configure a 7000 Series Managed Switch to provide the port routing support shown in the diagram.
Example 1. Enabling routing for the Switch
Use the following command to enable routing for the switch. Execution of the command enables
IP forwarding by default.
Figure 5-1
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
(Netgear Switch) (Config)#exit