Filter
Top Products
Advanced Settings
108
N750 Wireless Dual Band Gigabit ADSL Modem Router DGND4000
Wireless Repeater. The wireless modem router sends all traffic from its local wireless or
wired computers to a remote access point. To configure this mode, you have to know the
MAC address of the remote parent access point.
The DGND4000 wireless modem router is always in dual-band concurrent mode, unless you
turn of
f one radio. If you enable the wireless repeater in either radio band, the wireless base
station or wireless repeater cannot be enabled in the other radio band. However, if you
enable the wireless base station in either radio band and use the other radio band as a
wireless wireless modem router or wireless base station, dual-band concurrent mode is not
affected.
For you to set up a wireless network with WDS,
the following conditions have to be met for
both access points:
• Both acce
ss
points have to use the same SSID, wireless channel, and encryption mode.
• Both access
points have to be on the same LAN IP subnet. That is, all the access point
LAN IP addresses are in the same network.
• All LAN devices (wired and wireless computers) have to be configured to operate in the
same LAN ne
twork address range as the access points.
Wireless Repeating Function
Select ADVANCED > Advanced Setup > Wireless Repeating Function to view or change
wireless repeater settings for the wireless modem router.
• Enable Wireless Repeating Function. Select the check box for the 2.4-GHz or 5-GHz
network to use the wireless repeating function.
• Disable Wirel
ess Client Association. If your wireless modem router is the repeater,
selecting this check box means that wireless clients cannot associate with it. Only LAN
client associations are allowed.