Filter
Top Products
v1.0, September 2005
iv
ProSafe Dual Band Wireless Access Point (Product Name)
complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try and correct the interference by one or more of the following measures:
• Reorient or locate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Warning for North America, and Australia
Warning! To meet FCC and other national safety guidelines for RF exposure, the antennas for this device (see below)
must be installed to ensure a minimum separation distance of 20cm (7.9 in.) from persons. Further, the antennas shall not
be colocated with other antenna or radio transmitter.
Antenna Statement for North America and Australia
In addition to its own 2 antennas, the WAG102 device has been approved for use with the following detachable antennas
and antenna cables:
* WAG102 maximum radiated power in North America and Australia: 20 dBm – cable loss + antenna
gain
Please go to
www.netgear.com/go/wag102_fcc for an updated list of wireless accessories approved to be used
with the WAG102 in North America and Australia.
Industry Canada Compliance Statement
This Class B Digital apparatus meets all the requirements of the Canadian Interference Causing Equipment Regulations
ICES 003.
Cet appareil numerique de classe B respecte les exigences du reglement du Canada sur le materiel brouilleur NMB-003.
Approved An-
tennas
Antenna Gain and
type
Approved Antenna
Cable
Antenna Cable
Length
Maximum Trans-
mitted Power
NETGEAR
ANT24D18
18 dBi, directional
outdoor/indoor
NETGEAR ACC-
10314-01 thru 05
1.5 m to 30 m 19 dBm + 18 dBi
ant.
NETGEAR
ANT2409
9 dBi, omnidirec-
tional outdoor/in-
door
NETGEAR ACC-
10314-01 thru 05
1.5 m to 30 m 19 dBm + 9 dBi
ant.
NETGEAR
ANT24O5
5 dBi, ceiling/wall
indoor
NETGEAR ACC-
10314-01 thru 05
1.5 m to 30 m 19 dBm + 5 dBi
ant.