Filter
Top Products
Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
3-4 Basic Installation and Configuration
202-10060-02, February 2005
• Use WPA2-PSK. Wi-Fi Protected Access (WPA2) data encryption provides data security.
WPA2-PSK will block eavesdropping. Because this is a new standard, wireless device driver
and software availability may be limited. However, WPA2 is not available in bridge mode.
Installing the NETGEAR WG602v3 54 Mbps Wireless Access
Point
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings and configure the
advanced wireless functions.
Before installing the NETGEAR WG602v3 54 Mbps Wireless Access Point, you should make
sure that your Ethernet network is up and working. You will be connecting the access point to the
Ethernet network so that computers with 802.11b or 802.11g wireless adapters will be able to
communicate with computers on the Ethernet network. In order for this to work correctly, verify
that you have met all of the system requirements, shown on page 2-4.
1SET UP THE WG602V3 ACCESS POINT
Tip: Before mounting the WG602v3 in a high location, first set up and test the WG602v3 to
verify wireless network connectivity.
a. Prepare a PC with an Ethernet adapter. If this PC is already part of your network, record its
TCP/IP configuration settings.
b. Configure the PC with a static IP address of 192.168.0.210 and 255.255.255.0 for the
Subnet Mask.
c. Connect an Ethernet cable from the WG602v3 to the PC (A).
Figure 3-2: Set up the WG602v3
WG602 54Mbps
Wireless Access Point
ETHERN ET
A