Filter
Top Products
Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
Basic Installation and Configuration 3-21
202-10060-02, February 2005
You can copy and paste the MAC addresses from the WG602v3’s Station List page into the
MAC Address box. To do this, configure each wireless PC to obtain a wireless link to the
WG602v3. The PC should then appear in the Station List page.
4. Click Add to add the wireless device to the access list. Repeat these steps for each additional
device you want to add to the list.
5. Be sure to click Apply to save your wireless access control list settings.
Now, only devices on this list will be allowed to wirelessly connect to the WG602v3. For blocking
access from specific devices, follow the procedure above, except select the Block radio button.