Alteon OS Command Reference
42
First-Time Configuration 43W7774, May 2007
3. Next, decide whether to apply the changes at the prompt:
Enter
y to apply the changes, or n to continue without applying. Changes are normally applied.
4. At the prompt, decide whether to make the changes permanent:
Enter
y to save the changes to flash. Enter n to continue without saving the changes. Changes
are normally saved at this point.
5. If you do not apply or save the changes, the system prompts whether to abort them:
Enter
y to discard the changes. Enter n to return to the “Apply the changes?” prompt.
NOTE – After initial configuration is complete, it is recommended that you change the default
passwords as shown in “Setting Passwords” on page 43.
Optional Setup for Telnet Support
NOTE – This step is optional. Perform this procedure only if you are planning on connecting to
the GbE Switch Module through a remote Telnet connection.
1. Telnet is enabled by default. To change the setting, use the following command:
2. Apply and save SNMP and /or telnet configuration(s).
Apply the changes? [y/n]
Save changes to flash? [y/n]
Abort all changes? [y/n]
>> # /cfg/sys/access/tnet
>> System# apply
>> System# save