38
Chapter 4 Configurator Procedure for Creating a Node Profile
209664-A
3
Click OK. A display shows you the reset progress:
Setting the DNA Numbering Plan
To set the DNA numbering plan using Configurator, use the following steps:
1
Click on Configure.
2
Click on System.
3
Click on Identity. The System Identity window opens:
The DNA numbering plan is contained in the first part of the Device Network
Address.
4
If you’d like to change the DNA numbering plan to e164 (if this is required by
your Passport 6400), delete “[x121]”, and type “[e164]” before the DNA
prefix string. You will use x121 in Passport 4400 only networks.
Note:
Make sure that you don’t delete the DNA prefix string, which
appears after the DNA numbering plan.