Filter
Top Products
43
Getting Started with Passport 4400, Release 4.1
Chapter 5
Accessing the CLI and Basic Configuration
This chapter explains the basic configuration procedure using the Command Line
Interface (CLI) as your device management tool. Proceed with the following:
• “Using a Terminal” on page 43
• “Communication Parameter Set-Up Requirements” on page 44
• “Logging into the CLI Using the Terminal Emulation Program” on page 46
• “Assigning the IP Address” on page 47
The Passport 4460 is shipped from the factory with a pre-configured IP address
(192.168.200.200). After you have accessed your Passport 4460 using this IP
address, you should assign an IP address specific to your Passport 4460 network
through the CLI.
Using a Terminal
Before you can access the CLI in your Passport 4460 unit, you must have
followed the physical installation procedures found in Reference for Passport
4460 Hardware, 205677-A, and powered-up the unit.
Note:
This procedure can be done using any terminal emulation
program. The sample procedure below uses Windows 95’s
HyperTerminal program.