Filter
Top Products
46
Chapter 5 Accessing the CLI and Basic Configuration
209664-A
5
Set the following communication parameters for the terminal:
6
Click OK twice. You have now completed the HyperTerminal setup. Continue
on to Logging into the CLI Using the Terminal Emulation Program below.
Logging into the CLI Using the Terminal Emulation
Program
1
Access the terminal emulation program you set up for this connection. A
blank window opens.
2
Press [Enter] until you see a
Login
prompt.
3
At the
Login
prompt, type cli and press [Enter]. A
Password
prompt is
displayed.
4
Press [Enter]. You are now logged into the CLI and ready to initially
configure and assign an IP address to your Passport 4460 unit.
Continue on to Assigning the IP Address.
Data Rate 9600 bps
Data Bits 8
Stop Bits 1
Parity None
Flow control Xon/Xoff
Note:
If you are unable to connect to the Passport 4460, try selecting
Hardware in the flow control field.