Filter
Top Products
MCS 5100 RTP Media Portal Basics
15
Copyright © Nortel Networks Limited 2006
Figure 7 RTP Media Portal operational interface - single-network
deployment
Host CPU
As shown in Figure 8, Control and OAM interface - CPV5370 Host card
and RTP Media Portal, on page 16, the Rear Transition Module for the
host card (CPV5370) provides the following:
• COM2 port for connection to a terminal server and local monitor.
• Two Ethernet ports which provide connectivity to the Protected MCS
Network. The connection carries control and OAM data.
— The Ethernet 1 port is used to provide an active connection.
— The Ethernet 2 port provides a standby connection. The standby
ethernet function is enabled by default through the “Activate IP
Failover” property when configuring the RTP Media Portal. (For
additional information, refer to Table 2,
RTP Media Portal tab
configurable properties, on page 51.)
Network
Control/OAM
Media
Host
CPU
Media
Blades
RTP Media
Portal