Filter
Top Products
MCS 5100 RTP Media Portal Basics
97
Copyright © Nortel Networks Limited 2006
Figure 42 Red Hat: LILO Configuration
Select OK when finished.
3 Ensure /dev/sda for the location to install LILO is selected, and
select OK to continue.
4 Select OK to accept the default selection for the partition to boot
the Linux OS.
5 The Host Configuration screen will appear. Type in the host
name of the RTP Media Portal. Select OK when finished.
6 In the Network Configuration screen, de-select the bootp/DHCP
check box.
Enter nameserver IP addresses if they are available. If you enter
nameserver addresses, ENSURE THEY ARE CORRECT. The
RTP Media Portal will not function correctly if unreachable or
otherwise incorrect nameserver IP addresses are used. If you do
not have nameserver IP addresses, leave this field empty.
[ ] Use bootp/dhcp
IP address: <eth0 IP of Host Card>
Netmask: <Host Card Netmask>
Default gateway (IP): <Default Gateway>
Primary nameserver:
Select OK to continue.
LILO Configuration
A few systems will need to pass special options to the kernel
at book time for the system to function properly. If you need
to pass boot options to the kernel, enter them now. If you
don't need any or aren't sure, leave this blank.
[*] User linear mode (needed for some SCSI drives)
sonsole=ttyS1,9600n8..................................................
OK
Skip
Back