Filter
Top Products
Getting Started with the Contivity Extranet Switch 2500
7-4
Installing Option Cards
The following illustration shows you how install LAN or WAN option cards into
the Switch. You can use Slots 1 to 3 for any mix of LAN and WAN cards. Note
that Slot 4 is not supported.
Figure 7-3. Installing LAN or WAN Cards
1.
Power off the Switch and remove the power cord.
2.
Remove the top cover.
3.
Remove the filler panel screw and pull out the filler panel.
4.
Slide the option card into the intended slot. Make sure the card seats
firmly and evenly into the card slot. If the card is not seated properly, it
will not work.
5.
Replace the card, screw, and top cover.
Motherboard
Option Card
Filler Panel
Rear of Unit
Option Card Slots