Filter
Top Products
Connecting a WorkstationVariable Document_Name
11-6
Figure 11-3 displays a typical Ethernet connection.
Figure 11-3. Connecting a Passport 4400 Unit to the Ethernet
Reset Switch
A reset switch is located on the base module and can be accessed from the back
of the unit, as shown below. Use a small, pointed object to press the reset switch
through the hole in the back panel. The green reset indicator is also located on
the base module next to the reset switch.
Figure 11-4. Location of Reset Switch
Three types of resets are available depending on whether you are installing a
new Passport 4400 unit, replacing an existing Passport 4400 unit, or resetting
an existing Passport 4400 unit. Refer to Table 11-2 for the reset appropriate for
your installation.
Table 11-2. Using the Reset Switch
Press switch for... Type of reset Indicator
1-5 seconds Resets the CPU. Without diagnostics. On
6-10 seconds Resets by reading existing configuration from
flash. With diagnostics.
Slow flashing
10+ seconds Resets by restoring all configuration
parameters to their factory default values. WIth
diagnostics.
Fast flashing
Passport 4400
ortLAN P
Interface Card
Network
Reset indicator
Reset Switch