Filter
Top Products
6/28/2007 page 112 of 145
Set Priority Level
Command Name
port set prioritylevel
Description Sets the priority level of a given port.
Syntax port set prioritylevel <port-no><level>
Parameters
port-no
port number (1 ~ 14)
level
priority level (0 ~ 7)
Examples
N-TRON/Admin#[1]> port set prioritylevel 6 7
NOTES Priority State should be enabled to use this feature.
Show Configuration
Command Name
port show config
Description Displays basic configuration settings on given ports.
Syntax port show config <port-no | all>
Parameters
port-no | all
port number (1 ~ 14), you may enter all to see all the ports at once.
Examples
N-TRON/Admin#[1]> port show config all
NOTES Check whether port-no is in the valid range. (1 ~ 14)
Show Intruders
Command Name
port show intruder
Description Displays a list of MAC addresses that were not allowed on the network.
Syntax
port show intruder
Parameters None
Examples
N-TRON/Admin#[1]> port show intruder
NOTES Intruder log must be enabled before this will log anything.
Show Link Utilization
Command Name
port show linkutilization
Description Shows the utilization statistics for all the ports including %bandwidth, %in,
%out, RX bytes, and TX bytes for each port.
Syntax
port show linkutilization
Parameters None
Examples
N-TRON/Admin#[1]> port show linkutilization
NOTES %Bandwidth is the %in or %out value that is higher, not the average value.
Get Flow Control
Command Name
port get flowcontrol
Description Displays the current flow control settings on a given port.
Syntax port get flowcontrol <port-no>
Parameters
port-no
port number (1 ~ 14)
Examples
N-TRON/Admin#[1]> port get flowcontrol 6
NOTES Check whether port-no is in the valid range. (1 ~ 14)
Get Name
Command Name
port get name
Description Displays the name of a given port.
Syntax port get name <port-no>
Parameters
port-no
port number (1 ~ 14)
Examples
N-TRON/Admin#[1]> port get name 6
NOTES Check whether port-no is in the valid range. (1 ~ 14)