N-Tron 7014FX2 Switch User Manual


 
6/28/2007 page 39 of 145
VLAN – Port Based
The Port Based tab under the VLAN category shows all the VLANs that are configured on the switch and
details about the VLANs such as port numbers and tagged VLAN settings.
To add a VLAN simply click on the Add button on the page above and fill in the desired fields. The
example below would set up a basic port based VLAN for ports P1-P6.
(See VLAN Configuration Examples section)
Note:
1. When implementing overlapping VLANs, RSTP can only be enabled on one of the VLANs that is
overlapping others. RSTP can not be implemented on a VLAN that contains other VLANs within
that one. Changing anything on a VLAN will turn on RSTP on all VLANS as a precautionary
measure.
2. VLANs on N-Ring ports are limited to VID=1 (default) or VID=2. All N-Ring ports must be on
the same tagged VLAN.
3. VID=1 has to be Admit=ALL, and cannot be tagged only.