Filter
Top Products
(Revised 2010-11-15) Page 106 of 156
Configuration – Save or Reset
The Configuration section of web management gives an administrator the ability to save a running
configuration into the NVRAM. This step is needed in order for the switch to remember any changes after a
power cycle.
The ―Save‖ button will save all current changes to the configuration for use after the next power cycle.
Note: The current configuration will also be saved to the configuration device when connected. This
page reveals whether the configuration device is installed or not.
The ―Reset‖ button will discard all unsaved changes, reset the switch and load the most recently saved
configuration settings. Note: Upon restart, if a configured configuration device is connected, the switch
will load the configured settings from it and save them into NVRAM.
The ―Factory‖ button will reload N-Tron‘s factory default configuration settings. Doing so will reconfigure
the 700 Series switch to factory defaults. In many cases it is desirable to restore factory defaults but retain
the IP address, subnet mask, and gateway address settings as well as user names and passwords.
Checkboxes are provided to select the desired behavior. Note: The factory default configuration settings
will also be saved to the configuration device when connected.