Filter
Top Products
C3400n User’s Guide
104
through the drum cavity area. Then allow the pressure release
lever to rise again.
9. Starting with the cyan image drum unit nearest the fuser, replace
the four image drums into the drum cavity, making sure to locate
them in the correct order.
ID Positions_Fig1_04.jpg
• Holding the complete assembly by its top center, lower it into
place in the printer, locating the pegs at each end into their
slots in the sides of the printer cavity.
10. Lower the top cover but do not press down to latch it closed yet.
This will protect the drums from excessive exposure to room
lighting while you check the remaining areas for jammed sheets.
NOTE
If the sheet is well advanced into the fuser (only a short
length is still visible), do not attempt to pull it back. Follow the
next step to remove it from the rear of the printer.
1. Cyan cartridge 2. Magenta cartridge
3. Yellow cartridge 4. Black cartridge