Filter
Top Products
OkiLAN 8100e Configuration 30
> The Ethernet Address (MAC address) is displayed during the
self-diagnostic test.
3. AdminManager asks whether you want to initialise the network
interface card or not. Select [Yes]. Even if you select [No] here,
the IP address that you set can be used after turning the printer
OFF and ON. The requirement to turn your printer OFF and ON is
dependent on the network interface card.
Option Menu
In the [Option] menu, the following item can be selected:
Item Function
Use TCP/IP Protocol If this item is selected, AdminManager uses TCP/IP protocol to
search/configure network interface cards.
Use IPX/SPX
Protocol
If this item is selected, AdminManager uses IPX/SPX protocol to
search/configure network interface cards.
Environment Setup TCP/IP Tab Set broadcast addresses that are used to
search OKI network interface cards using the
TCP/IP protocol. If [Use TCP/IP protocol] is
unchecked, the search will not be carried out
using TCP/IP.
NetWare Tab Set network addresses that are used to
search OKI network interface cards via
NetWare protocol. If there any many NetWare
file servers on your network, specify the
network address to which the network card
belongs. If [Use NetWare protocol] is
unchecked, the search will not be carried out
using NetWare, but if [Auto Search] is
selected, AdminManager will search all
networks that AdminManager can detect.
TimeOut Tab [Search Every]: Set response waiting time
from a network card in seconds.
[Time Out]: Set time out between
AdminManager and the network interface
card in seconds.
[Retry]: Set how many times the retry will be
carried out between AdminManager and the
network interface card.