Filter
Top Products
Appendix A
38
Appendix A
39
Programming Code: Serial Command:
A bar code to program the command. If a serial command is available then you can
send the program the LH2 via serial port.
All the commands end with a carriage
return.
<┘ represents a carriage return.
Example:
P%081<┘
Note:
Extra notes on the command will be mentioned here. Usually these
notes are important so please pay special attention to this section.
Options:
If extra programming command options are available then it will
be listed here. It follows the same syntax as mentioned in the
Programming Code and Serial Command section.
Programming Bar Codes
The LH2 imagers are pre programmed at the factory with default settings representing the
settings most commonly used by our customers. In most applications, the imager will work
right out of the box without the need for additional programming.
You can scan the barcodes from the appendix to change the settings of the LH2. The LH2
will automatically recognize the barcode as a programming barcode and change the settings
accordingly. You can scan multiple programming barcodes to change the settings.
NOTE: Always scan the “Save Settings“ bar code to save all the changes you made. If
you do not save the settings then the next time you power ON the LH2, it will go to the
previously saved settings.