Filter
Top Products
Packard Bell EasyNote ST Disassembly Manual
2
About this Guide
This guide contains systematic disassembly instructions for the Packard Bell EasyNote ST. The
instructions are illustrated where necessary with images of the part that is being disassembled.
Packard Bell B.V. reserves the right to make changes to the EasyNote ST without notice.
For More Information
For more information about the Packard Bell EasyNote ST, visit Packard Bell‘s support web site at
www.packardbell.com
. The support web site also has links to additional Packard Bell
documentation and detailed product specifications.
Technician Notes
Only technicians authorized by Packard Bell B.V. should attempt to repair this equipment. All
troubleshooting and repair procedures are detailed to allow only subassembly/module level repair.
Because of the complexity of the individual boards and subassemblies, no one should attempt to
make repairs at the component level or to make modifications to any printed wiring board.
Improper repairs can create a safety hazard. Any indication of component replacement or printed
wiring board modifications may void any warranty or exchange allowances.
Disassembly
When disassembling the system unit, follow these general rules:
Turn OFF the power to the system and all peripherals using the power button.
Unplug the AC adapter and all power and signal cables from the system.
Remove any SD/MMC card, ExpressCard or dummy card from the computer.
Do not disassemble the system into parts that are smaller than those specified in the
instructions.
Label all removed connectors; note where the connector goes and in what position it was
installed.
The screws for the different components vary in size. During the disassembly process,
group the screws with the corresponding components to avoid mismatch when putting back
the components.
Reassembly
Reassembly is the reverse of the disassembly process. Use care to ensure that all cables and
screws are returned to their proper positions. Check that no tools or any loose parts have been left
inside the casing. Check that everything is properly installed and tightened.
Required Tools
To disassemble the computer, you need the following tools:
Wrist grounding strap and conductive mat for preventing electrostatic discharge.
Small Phillips screwdriver.
Small flat screwdriver.