16
Operation
Starting Up/Shutting Down
3
Log on to Windows.
After confirming that the hard disk drive indicator ( ) has turned off, select the user
and input the password, then select . Until the correct password is entered, the
computer will not operate.
4
Select your application.
You are able to start working on your computer.
The power saving function is factory set, so if there is no input from a key, the touch
pad, the touchscreen (only for models with touchscreen) or an external mouse (when
one is connected) for a certain interval of time, the power to the LCD and hard disk
may be turned off. The LCD will resume operation when the touch pad, the touch-
screen (only for models with touchscreen) or an external mouse (when one is con-
nected) is used or a key is pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode ( “Standby/Hibernation Functions”). The computer will
resume by pressing the power switch.
NOTE
If the screen on the left is displayed immediately after you turn
on the power...
A password has been set to ensure the computer’s security.
Enter your password*
1
and press Enter . ( “Security Measures”)
When the correct password is input, the computer will start.
When three incorrect password attempts or nothing is input for one minute, the com-
puter will power off.
*
1
Supervisor Password or User Password set in the Setup Utility (not the Windows password).
Enter Password [ ]