Filter
Top Products
15
Setup as SMTP mail server
To install the DX-2000 as SMTP mail server, the following network parameters need to be programmed on your
network and on the DX-2000.
• IP Address of the DNS Server (if not available, see Note)
• IP Address of the DX-2000
• Subnet Mask of the DX-2000
• Name or IP Address of the Default SMTP mail server
• IP Address of the Default Router
• Email Address of the DX-2000 (see Note)
• Host Name
(see Note 1) (see Note 2) (see Note 3)
Email Transmission (from the DX-2000 to a PC)
Email reception (from a PC to the DX-2000)
1. To function as SMTP mail server, the DX-2000’s email address must include its unique Host name within your
company domain. This unique Host name must be registered within your network’s DNS (Domain Name System)
server. Example: DX2000@fax01.panasonic.com
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter the SMTP Server
Name. If the DNS Server is not available, change the Fax Parameter No. 161 (DNS SERVER) to "1:Invalid". Then
the machine will prompt you to enter the IP Address of the SMTP Server.
3. Dynamic Host Configuration Protocol (DHCP) is not supported.
DX2000@fax01.panasonic.com
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
(Router)
popuser001@panasonic.com
SMTP
POP3
DX2000@fax01.panasonic.com
SMTP01.panasonic.com
(SMTP Mail Server)
(Router)
popuser001@panasonic.com
SMTP
Pre Installation Information
Note:
1