Filter
Top Products
DISPLAY MESSAGE CAUSE AND REMEDY
59
Troubleshooting
and Routine Care
Error messages on the display
If the unit detects a problem, one or more of the following messages will appear on the display.
¡There is something wrong with the unit. Contact our service personnel (p. 72).
¡The front cover is open. Close it.
¡The document is not fed into the unit properly. Reinsert the document. If
misfeeding occurs frequently, clean the document feeder rollers inside the unit
(p. 69). If the problem remains, adjust the feeder pressure (p. 66).
¡The film cartridge is not inserted properly. Reinsert it correctly (p. 67, 68).
¡The recording paper lever is released. Push it back to set the lever (p. 9).
¡Memory (phone numbers, parameters, etc.) has been erased. Re-program.
¡The recording paper is not installed or the unit ran out of paper. Install paper
(p. 8).
¡The recording paper is not fed into the unit properly or has jammed near the
recording paper entrance. Clear the jammed paper (see “When paper has
jammed near the recording paper entrance” on page 65).
Do not install folded or heavily curled paper in the paper tray.
¡The unit has (a) document(s) in memory. See the other message’s instructions to
print out the document(s).
¡The film is empty. Replace the film or film cartridge with a new one (p. 67, 68).
¡The film is slack. Tighten it (see step 8 on page 68) and install again.
¡The remaining film can print approx. 15 pages of letter size documents. Prepare a
new film or film cartridge (p. 6).
¡The memory is full of received documents due to a lack of recording paper or a
recording paper jam, etc. Install paper or clear the jammed paper.
¡When performing memory or multistation transmission, the document being stored
exceeds the memory capacity of the unit. Transmit the entire document by using
manual or automatic transmission.
¡The receiving unit is busy or ran out of recording paper. Try again.
¡A recording paper jam occurred under the film cartridge. Clear the jammed paper
(p. 64).
¡The unit is checking if the film is set correctly. Wait for a while.
CHECK COVER
CHECK DOCUMENT
CHECK MEMORY
MEMORY FULL
NO RESPONSE
PAPER JAMMED
CHECK FILM
CHECK LEVER
CHECK PAPER
FAX IN MEMORY
FILM EMPTY
FILM NEAR EMPTY
CALL SERVICE
(continued)
PLEASE WAIT
Troubleshooting