Filter
Top Products
Remote Operation
78
Other remote operations
Erasing a specific message
Press {
{{
{*
**
*}{
}{}{
}{4}
}}
} while listening to the message
you want to erase.
Voice guide example:
“The message has been erased.”
L A long beep will sound. The unit will then play
back the next message.
Erasing all the messages
Press {
{{
{*
**
*}{
}{}{
}{5}
}}
} to erase all the messages.
Voice guide example:
“All messages have been erased.”
L A long beep will sound.
Monitoring the room
Press {
{{
{6}
}}
} to monitor the sound for about 30
seconds in the room where the unit is installed.
L After 30 seconds, a beep will sound. To
continue monitoring, press {
{{
{6}
}}
} again within
10 seconds.
Recording a marker message
After playing back the recorded messages, you
can leave an additional message.
1. Wait for the voice guide.
Voice guide example:
“All messages have been played.”
2. Wait about 10 seconds.
Voice guide example:
“Please leave your name and message after
the beep.”
3. Leave a message after the beep.
Re-recording a greeting message
You can change the contents of the TAD/FAX
greeting message.
1. Press {
{{
{7}
}}
} to start recording.
L A long beep will sound.
2. Speak clearly up to 16 seconds.
L If you pause for over 2 seconds, 6 beeps
will sound and the recording will stop.
Repeat from step 1 within 10 seconds.
3. When finished recording, press {
{{
{9}
}}
}.
L The new greeting message will be played.
Skipping the greeting message
Press {
{{
{0}
}}
} during the greeting message
playback.
L The unit will skip the rest of the greeting
message.
Turning the message transfer on or off
You must program a transfer telephone number
beforehand (feature #60, page 91).
Press {
{{
{8}{
}{}{
}{1}
}}
} to turn on the message transfer.
Voice guide example:
“Message transfer is set. Transfer phone
number is 123...”
Press {
{{
{8}{
}{}{
}{2}
}}
} to turn off the message transfer.
Voice guide example:
“Message transfer is off.”
L If a transfer telephone number is not
programmed, you cannot turn this feature on.
Voice guide example:
“Transfer phone number is not set.”
Turning the pager call on or off
You must program a pager number beforehand
(feature #70, page 91).
Press {
{{
{8}{
}{}{
}{3}
}}
} to turn on the pager call.
Voice guide example:
“Pager call is set. Pager number is 098765432.”
Press {
{{
{8}{
}{}{
}{4}
}}
} to turn off the pager call.
Voice guide example:
“Pager call is off.”
L If a pager number is not programmed, you
cannot turn this feature on.
Voice guide example:
“Pager number is not set.”
Changing the receive mode
Press {
{{
{8}{
}{}{
}{0}
}}
} to change the receive mode from
TAD/FAX to TEL.
L You cannot return to TAD/FAX mode in the
same call. To return to TAD/FAX mode, see
the following.
Setting to TAD/FAX mode from TEL mode
1. Call your unit and wait for 10 rings.
L The answering device will temporarily
answer the call.
2. Enter the remote operation ID during the
greeting message.
L A long beep will sound, and your unit will
switch to TAD/FAX mode.
3. Hang up the handset.