Filter
Top Products
R P
ress any dial key, M
N,
or MSNOOZEN to
stop the sound but keep the snooze
function activated.
R If you want to make an outside call when
the snooze function is activated, please
stop the snooze function before making the
call.
Silent mode
S
ilent mode allows you to select a period of
time during which the handset will not ring for
outside calls. This feature is useful for time
periods when you do not want to be disturbed,
for example, while sleeping. Silent mode can
be set for each unit.
Using the phonebook’s group feature
(page 27), you can also select groups of
callers whose calls override silent mode and
ring the handset (Caller ID subscribers only).
Important:
R Make sure the unit’s date and time setting
is correct (page 14).
R We recommend turning the base unit ringer
off (page 34, 35) in addition to turning the
silent mode on.
R If you have set the alarm, the alarm sounds
even if the silent mode is turned on.
Turning silent mode on/off
1 MM
ENUN (right soft key) #238
2 MbN: Select the desired setting. a
MSAVEN
R If you select “Off”, press MOFFN to
exit.
3 Enter the desired hour and minute you
wish to start this feature.
4 *: Select “AM” or “PM”. a MOKN
5 Enter the desired hour and minute you
wish to end this feature.
6 *: Select “AM” or “PM”.
7 MSAVEN a MOFFN
Changing the start and end time
1 MMENUN (right soft key) #237
2 C
ontinue from step 3, “Turning silent
mode on/off”, page 40.
Selecting groups to bypass silent
m
ode
1 MMENUN (right soft key) #241
2 Select your desired groups by pressing
1 to 9.
R “
” is displayed next to the selected
g
roup numbers.
R To cancel a selected group, press the
same dial key again. “
” disappears.
3 MS
AVEN a MOFFN
Call block
T
his feature rejects calls from unwanted
callers (Caller ID subscribers only). The
following items are available when storing
phone numbers in the call block list (250 max.).
– “Block a single number”: The unit
can reject calls from specific phone
numbers.
– “Block range of numbers”: The unit
can reject calls that begin with a number
stored in the call block list, such as a
toll-free phone number prefix or certain
area codes.
You can also set the unit to reject calls that do
not have a phone number.
When a call is received, the unit rings briefly
*1
while caller information is being received. If
the caller’s phone number matches an entry in
the call block list, the unit emits no sound to
the caller, and disconnects the call.
*1 This is called first ring. If you do not want
the first ring to sound, turn this setting to
“Off” (page 41).
Important:
R Rejected calls are logged in the caller list.
40
For assistance, please visit http://www.panasonic.com/help
Programming
TGH26x(en)_1217_ver051.pdf 40TGH26x(en)_1217_ver051.pdf 40 2013/12/17 18:31:492013/12/17 18:31:49