Filter
Top Products
Display message Cause/solution
Requires
s
ubscription
to Caller ID.
R You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
Use
r
echargeable
battery.
R A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 7.
Troubleshooting
I
f you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
Problem Cause/solution
The handset does not turn on
e
ven after installing charged
batteries.
R Place the handset on the base unit or charger to turn on
the handset.
The unit does not work. R M
ake sure the batteries are installed correctly (page 10).
R Fully charge the batteries (page 11).
R Check the connections (page 10).
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset has not been registered to the base unit.
Register the handset (page 42).
The handset display is blank or
d
ark.
R The handset is in screen saver mode (page 15). Activate
the handset display again by:
– pressing M
N
when on a call.
– pressing MOFFN at all other times.
R “LCD backlight” is set to “Off” while on charge.
Change the setting (page 37).
For assistance, please visit http://www.panasonic.com/help
61
Useful Information
TGH26x(en)_1217_ver051.pdf 61TGH26x(en)_1217_ver051.pdf 61 2013/12/17 18:31:512013/12/17 18:31:51