Filter
Top Products
43
Receiving Faxes
Pager call - when the unit receives a fax or !
voice message!
This feature allows your unit to call your pager when your unit receives a fax document or an
incoming voice message.
1
Press .
Display:
2
Press , then .
3
Press or to select “ON”.
●
If this feature is not required, select
“OFF”.
4
Press .
5
Enter your pager number up to 30 digits.
Example:
6
Press .
7
Enter your pager access code up to 10
digits if required.
Example:
8
Press .
●
The default code 07734 will show
“Hello!” on your pager.
●
If you want to change this message,
enter your message up to 30 digits.
Example:
MSG.=5555
MSG.=07734
SET
PIN=12345678
PIN=
SET
NO.=12025551234
NO.=
SET
PAGER CALL
MODE=ON [±]
PAGER CALL
MODE=OFF [±]
7 0
SYSTEM SET UP
PRESS NAVI.[I H]
MENU
SET
Display
MENU
DIGITAL SP-PHONE
Note:
●
If
you have subscribed to a Caller ID service,
your pager will display the caller’s telephone
number before the number “11” or “22” (see
below) instead of the message.
9
Press .
●
The unit will dial the stored
number.
10
Check that your pager received
the pager test call.
11
Press .
DIGITAL SP-PHONE
PAGER TEST
SET
Your pager will beep and display as follows;
— “11” : when your unit receives a voice
message.
— “22” : when your unit receives a fax
document.
Pager
22
Example:
Your unit received
a fax document.
When your pager receives a pager call