Filter
Top Products
58
Remote Operation
Press to turn ON the pager call.
8 3
■
Turning the pager call on or off
You must program a pager number beforehand
(feature #70 on page 43).
Press to turn OFF the pager call.
8 4
●
If a pager number is not programmed, you
cannot turn this feature ON.
■
Returning to TAD/FAX mode
1. Call your unit and wait for 10 rings.
●
The answering device will temporarily answer
the call.
2. Enter the remote operation ID during the
greeting message.
●
Your unit will switch to TAD/FAX mode.
■
Changing the receive mode
Press to change the receive mode from
TAD/FAX to TEL.
●
You cannot return to TAD/FAX mode in the same
call. To return to TAD/FAX mode, see below.
8 0
Pager call is set.
Pager number is 098765432.
Pager call is off.
Pager number is not set.
Press to turn ON the message transfer.
8 1
■
Turning the message transfer on or off
You must pre-program a transfer telephone
number beforehand (feature #60 on page 68).
Press to turn OFF the message transfer.
8 2
●
If a transfer telephone number is not
programmed, you cannot turn this feature ON.
Message transfer is set.
Transfer phone number is 123···.
Message transfer is off.
Transfer phone number is not set.
■
Skipping the greeting message
Press during the greeting message playback.
●
The unit will skip the rest of the greeting
message.
0
■
Erasing a specific message
Press while listening to the message you
want to erase.
●
A long beep will also sound. The unit will then
play back the next message.
■
Erasing all the messages
You can erase all of the recorded messages from
the common memory and each mailbox memory.
To erase all of the messages in a mailbox, you
must first select the mailbox.
Press to erase all the messages.
●
A long beep will also sound.
5
4
Other remote operations
Voice guide example:
1. Wait for the voice guide.
2. Wait about 10 seconds.
3. Leave a message after the beep.
■
Monitoring the room
Press to monitor the sound for about 30
seconds in the room where the unit is installed.
●
After 30 seconds, a beep sounds. To continue
monitoring, press again within 10 seconds.
6
6
■
Recording a marker message
You can leave an additional message.
The message has been erased.
All messages have been erased.
All messages have been played
.
Please leave your name and
message after the beep.
■
Re-recording a greeting message
You can change the contents of the greeting
messages for TAD/FAX mode and mailbox
memories. To re-record a mailbox greeting
message, you must first select the mailbox.
1. Press to start recording.
●
A long beep will sound.
2. Speak clearly up to 16 seconds.
●
If you pause for over 2 seconds, 6 beeps
will sound and the recording will stop.
Repeat from step 1 within 10 seconds.
3. When finished recording, press .
●
The new greeting message will be played.
9
7