Filter
Top Products
21
Setting Machine
Continued on the next page...
Job Tracking Setting
This enables or disables Job Tracking. If Job Tracking is enabled, also set the type of log to record and the
Email address to which it is to be sent.
Login to the machine, and press
FUNCTION
SET
.
ENTER ACCESS CODE
Enter the access code (4-digit) set for the machine, and press
SET
.
ENTER ACCESS CODE
****
Press , and then
SET
.
FAX PARAMETER(1-182)
NO.=
Enable ("VALID") or disable ("INVALID") the Job Tracking function.
SET
: Enables Job Tracking.
SET
: Disables Job Tracking.
If you selected (VALID), next specify the type of log to record and
the Email address to which it is to be sent.
131 JOB TRACKING
1:INVALID
JOB TRACKING=1
1:TX 2:RX 3:TX&RX
Select the type of log to record.
SET
: (TX&RX) Record sending and receiving.
SET
: (RX) Record receiving only.
SET
: (TX) Record sending only.
A prompt appears for entering the destination Email address.
JOB TRACKING
ENTER ADMIN. ADDR
Specify the Email address to which to send the log.
Select the destination Email address to which to send the log from
the addresses previously set in One-Touch/ABBR. keys.
Panasonic User
panauser@pana.com
Press
SET
.
Note:
Before performing this setup, you rst need to register the destination Email address for the log in One-Touch/ABBR.
keys. Furthermore, change the setting of the Fax Forward (Fax Parameter No. 54, FAX FORWARD) parameter to
Invalid.
When the User Authentication function is enabled, you must login to the machine to change settings. See the following
sections for details about how to login.
See "Administrator Login" on page 24 for Logging in as the system administrator.
See "Login Procedure" on page 8 for Logging in as a user.
The Job Tacking Settings are cleared if the Authentication Setting of all functions is changed to Invalid.
Set the POP Parameters so as to receive the emails automatically when using the Job Tracking function. Otherwise,
your machine cannot receive any emails.
Make sure that the Fax Parameters are NOT set as below.
Auto POP Receive (Fax Parameter No. 147) : Invalid
POP Timer (Fax Parameter No. 146) : 0 minute