Filter
Top Products
29
Disconnect the power supply from the projector before installing any of the input modules.
Installation procedure
Remove the two screws which are holding the slot cover where the input module is to be installed, and then
remove the slot cover.
Fit the input module into the slot rails, and then push the input module in until it is seated in the connector, while
being careful not to bump any of the module components.
Tighten the two screws to secure module in place.
Remove the slot cover
Slot cover
Remove the
two screws
Insert the input module
Input module
Slot
Secure the input module
Register input signal
Tighten the two screws
With this equipment, it is necessary
to store the input signal after
installing the input module. (Refer to
pages 42 and 43 for details on
registering input signals.)
•
Installing the input modules
• Up to three input modules can be installed.
• Do not remove any of the covers on spare slots
where no input module has been installed.
• Be sure to install input modules in the slot 1,
slot 2 and slot 3 positions.
NOTE