Filter
Top Products
78 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Note
rf
When [ECO] is set, the power consumption and operation sound can be reduced while the lamp life can be increased.
[STANDBY MODE]
Set the power consumption during the standby.
1)
Press as to select [STANDBY MODE].
2)
Press qw to switch [STANDBY MODE].
rf
The setting will change between [NORMAL] and [ECO] each
time you press the button.
rr
[STANDBY MODE]
[NORMAL] Normally use this setting.
[ECO] Use this setting to reduce power consumption during standby.
Note
rf
When set to [ECO], network functions and <SERIAL OUT> terminal are not available during standby. Also, some RS-232C commands are
not available. When set to [NORMAL], network functions and <SERIAL OUT> terminal are available during standby.
rf
When set to [ECO], display may delay about 10 seconds when the power is turned on, compared to the [NORMAL] setting.
[SCHEDULE]
Set the command execution schedule for each day of the week.
Enabling/disabling the schedule function
1)
Press as to select [SCHEDULE].
2)
Press qw to switch [SCHEDULE].
rf
The setting will change between [OFF] and [ON] each time you
press the button.
rr
[SCHEDULE]
[OFF] Disables the schedule function.
[ON]
Enables the schedule function. Refer to “How to assign a program” (
x
page 78) or “How to set a
program” (
x
page 78) in regard to how to set the schedule.
Note
rf
When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.
Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].
How to assign a program
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the
<ENTER> button.
rf
The [SCHEDULE] screen is displayed.
3)
Select and assign program to each day of
week.
rf
Press
as
to select the day of week, and press
qw
to select a
program number.
rf
You can set the program from No.1 to No.7. “- - -” indicates that
the program number has not been set yet.
How to set a program
You can set up to 16 commands to each program.
1)
Press as to select [SCHEDULE].
2)
Press qw to select [ON], and press the
<ENTER> button.
rf
The [SCHEDULE] screen is displayed.
3)
Press as to select [PROGRAM EDIT].
4)
Press qw to select a program number and
then press the <ENTER> button.
5)
Press as to select a command number and
press the <ENTER> button.
rf
You can change the page using
qw
.
6)
Press as to select [TIME], and press the
<ENTER> button.
7)
Press qw to select hour and minute, and press
as or the number (<0> to <9>) buttons to set
a time, and press the <ENTER> button.
8)
Press as to select [COMMAND].