Filter
Top Products
ENGLISH-25
Basic Operation
24-ENGLISH
Press the input select button to select the
input signal.
B
A picture will be projected in accordance with the selected input signal.
Follow the procedure below when you set the projector up first, and when
you change the setup place.
Press the AUTO SETUP button to initiate
automatic positioning.
BThe tilt of the projector and the input
signal will be detected and keystone
distortion and the position of the
image will be corrected.
(Refer to page 27 for details.)
Adjusting the size
BTurn the zoom ring to adjust the size of the projected image.
Adjusting the focus
BTurn the focus ring to adjust the focus of the projected image.
AUTO SETUP
Input select
buttons
PT-L735NTE
only
Changing
signals
VIDEO
S-VIDEO
RGB1
RGB2
&
'
)
*
(
Adjusting the angle
BWhile pressing the adjuster buttons,
adjust the forward/back angle of tilt
of the projector. Adjust so that the
projector is as vertical to the screen
as possible.
RGB1 RGB2
NETWORK
SDCARD
RGB
VIDEO
RGB
Turning off the power
Press the POWER button.
B“Power OFF” is displayed on the
screen.
Select “OK” using the
II
and
HH
buttons and
then press the ENTER button.
BThe lamp unit will switch off and the picture will stop being projected.
(The power indicator on the projector will illuminate orange.)
#
$
%
AUTO SETUP
LASER
MENUVIDEO
PAGE
ENTER
R-CLICK
RGB
POWER
#
$
%
RGB input indicator
Power indicator
Power OFF
OK CANCEL
Press the MAIN POWER switch to turn off the
power after the power indicator on the
projector illuminates red.
Direct power off function
You can turn off the MAIN POWER switch and move the projector immediately after use.
The cooling fan will operate by the internal power supply to cool down the lamp.
B
When this function is used, it may take more time for the lamp to turn back on again
compared to when the lamp cools down while the MAIN POWER switch is ON.
B
Do not put the projector in a bag while the cooling fan is operating.