Filter
Top Products
ENGLISH-51
Adjustments and settings
50-ENGLISH
CHANGE TEXT
The setup letters which will be
displayed when TEXT DISPLAY is
set to “ON” can be changed.
Press the ENTER button to display
the CHANGE TEXT screen.
#Use the F, G, I and H buttons
to select the characters, then
press the ENTER button.
(You can enter 20 characters
continuously.)
<Editing Items>
←
Moves cursor to left.
→
Moves cursor to right.
DELETE
Deletes a letter on the cursor.
ALL DELETE
Deletes all the letters.
$Use the F, G, I and H buttons
to select “OK”, then press the
ENTER button.
CSelect “CANCEL” to cancel the
change.
TEXT DISPLAY
The setup letters can be displayed
at the bottom of the projected image
while an image is projected.
ON
TEXT DISPLAY is enabled.
OFF
TEXT DISPLAY is disabled.
LOGO DISPLAY
A logo can be displayed before
projection.
ON
LOGO DISPLAY is enabled.
OFF
LOGO DISPLAY is disabled.
LOGO CLEAR
Captured logo data can be cleared.
Press the ENTER button to display
the confirmation screen, and then
select “OK”.
LOGO CAPTURE
A logo can be captured from the
picture being projected. Press the
ENTER button to display the
capture adjustment screen.
#
Use the
FGIH
buttons to
move the capturing frame to the
area you want to capture.
$Press the ENTER button.
CThe letters “CAPTURE ...” and
the progress status will be
displayed while logo capture is
being carried out.
'
NOTE:
BThe entered password will
appear as . It will not be
displayed on the screen.
BIf you enter the wrong
password, the letters
“PASSWORD” and “NEW” will
become red. Enter the correct
password again.
Cursor
Editing items
Above: Setting before change
Below: Setting after change
POSITION:[{ } ^ @]
CAPTURE:[ENTER]
CANCEL:[MENU]
Capturing frame
NOTE:
BThe size of the capturing frame
varies depending on the
signals being input.
BFine images such as
landscapes may be unable to
be captured.
BOnly RGB signals can be
captured. (Except 525i, 625i,
525p, HDTV60, HDTV50, and
750p. Refer to page 62 for
details.)
BImages with 512x384 pixels
can be captured.
BIt is recommended that you
input XGA signals, and set
KEYSTONE to “0” when
carrying out LOGO CAPTURE.
NOTE:
BThe letters which cannot be
input will be displayed in gray,
and cannot be selected in
CHANGE TEXT.