Filter
Top Products
Projector <Top, right and front>
ENGLISH-13
Preparation
12-ENGLISH
#Security lock
This can be used to connect a
commercially-available theft-
prevention cable (manufactured
by Kensington). This security lock
is compatible with the Microsaver
Security System from
Kensington. Contact details for
this company are given below.
Kensington Technology Group
ACCO Brands Inc.
2855 Campus Drive
San Mateo, CA 94403 USA
Tel (650)572-2700
Fax (650)572-9675
http://www.kensington.com/
http://www.gravis.com/
$Remote control signal receptor
(page 22)
%Air outlet port
Do not cover this port.
&Carrying handle
'Speaker (R)
(Lamp unit holder
(page 56)
WARNING
Do not bring your hands or other
objects close to the air outlet port.
BHeated air comes out of the air
outlet port. Do not bring your
hands or face, or objects which
cannot withstand heat close to
this port, otherwise burns or
damage could result.
Projector <Back and bottom>
Location and function of each part
#Focus ring
(page 24)
$Zoom ring
(page 24)
%Projector control panel
(page 14)
&Connector panel
(page 16)
'MAIN POWER switch
(pages 23 and 25)
(Power input socket (AC IN)
(page 23)
The accessory mains lead is
connected here.
Do not use any mains lead other
than the accessory mains lead.
)Speaker (L)
*Air inlet ports
Do not cover these ports.
+Air filter
(page 54)
,Front adjustable legs(L/R)
(page 24)
-Leg adjuster buttons(L/R)
(page 24)
These buttons are used to unlock the
front adjustable legs. Press to adjust
the angle of tilt of the projector.
.Remote control signal receptor
(page 22)
/Lens cover
0Projection lens
1Wireless card slot
(PT-L735NTE only)
Insert the wireless card into here.
(Refer to page 17.)
2Eject switch
(PT-L735NTE only)
Use to remove the wireless card
from the card slot.
3Access lamp
(PT-L735NTE only)
Flashes while the projector is being
accessed for reading or writing the
data in the SD memory card.
4SD memory card slot
(PT-L735NTE only)
Insert the SD memory card into
here.
NOTE:
BDuring projection of an image,
the cooling fan will operate,
emitting a small noise as it
operates. Turning the lamp on
or off will cause this noise to
increase a little.
B
By using the OPTION menu to set
LAMP POWER to
“
LOW
”
, the
operating sound of the fan can be
reduced. (Refer to page 46.)
/
,
-
*
#
$
0
. -,
(
1
3
4
2
% & '
+ * )
PT-L735NTE only
&%$
#
'
(
NOTE:
BInformation given above may
be changed in future.