Panasonic TQBJ0299-3 Projector User Manual


 
Getting Started
ENGLISH - 10
Connections
Read and follow the operating and connecting instructions of each peripheral device.
The peripheral devices must be turned off.
Use cables that match each peripheral device to be connected.
If the input signal is affected by signal jitter, the projected image may have poor image quality and timebase
correction is effective.
Confirm the type of video signals.
The projector accepts the following signals: VIDEO, S-VIDEO, analogue-RGB (with TTL sync. Level) and
digital signal.
Some computer models are not compatible with the projector.
When using long cables to connect with each of equipment to the projector, there is a possibility that the
image will not be output correctly unless a compensator is used.
Before connection to the projector
Pin assignments and signal names
J S-VIDEO IN J RGB2 IN
Pin No. Signal names Pin No. Signal names
1 Ground (luminance) 1 R/PR
2 Ground (colour) 2 G/G • SYNC/Y
3 Luminance signal 3 B/P
B
4 Colour signal 12 DDC data
13 HD/SYNC
14 VD
15 DDC clock
J DVI-D IN
Pin No. Signal names Pin No. Signal names
1 TMDS Data 2- 13
2 TMDS Data 2+ 14 +5V
3 TMDS Data 2/4 shield 15 GND
4 16 Hot Plug Detect
5 17 TMDS Data 0-
6 DDC clock 18 TMDS Data 0+
7 DDC data 19 TMDS Data 0/5 shield
820
9 TMDS Data 1- 21
10 TMDS Data 1+ 22 TMDS clock shield
11 TMDS Data 1/3 shield 23 TMDS clock+
12 24 TMDS clock-
1
4
3
2
3
69
14 11
41
8
15 12
52
710
13
4, 9:
Not assigned
5 - 8, 10, 11:
GND terminals