Filter
Top Products
ADVANCED MENU
ENGLISH - 23
Settings
(Not available for PT-D5000)
The built-in edge blending feature allows multiple projector
images to be seamlessly overlapped by adding a brightness
ramp. Press F G to select the required option.
Q Adjusting EDGE BLENDING
1. Select ON and press the ENTER button to display the
detailed options.
2. Switch between ON/OFF of the required connecting
edge.
3. Press I H to adjust the value of START and WIDTH.
WIDTH of the both projectors must be the same value.
Q Adjusting with colour markers
You can adjust with colour markers, which indicate the
overlapping area.
1. Press G several times until MARKER is displayed.
2. Select MARKER and press I H to switch between ON/
OFF.
Green and red lines will be displayed.
Green line indicates START point, and red line indicates
WIDTH from START point.
Adjust START and WIDTH for superimposing the green line
to the red.
Q Selecting gamma level
You can adjust gamma level of the lapping area for fine
adjustment.
1. Select GAMMA and press the ENTER button.
2. Press I H to cycle through the options.
Options are 2.2, 1.8 and 2.0.
3. Press the ENTER button to apply the setting.
EDGE BLENDING
OFF Deactive
ON
Adds a brightness ramp to the
overlapped area and adjustable the
overlapping position manually.
Vertical connecting
Horizontal connecting
Overlapped
Projector 1
LOWER: ON
Projector 2
UPPER: ON
Overlapped
Projector 1
RIGHT: ON
Projector 2
LEFT: ON
Projector 1
Projector 2
Overlapping area
Green lines
Red lines