Filter
Top Products
10
TA PE CA SSE TT E
A single LS7 tape cassette is supplied with this unit. This machine has been designed to
allow the tape cassette to be changed quickly and easily.
To change the LS7 tape cassette:
1 Remove the back cover by pressing in on the rough area at the top end of the machine
and pulling off the cover. Pulling off the back cover lifts up the tape release lever.
2 If a tape cassette is already installed, remove it by pulling it straight out.
3 If the ink ribbon in the other tape cassette is loose, use your finger to wind the toothed
wheel in the direction of the arrow on the cassette until there is no slack in the ribbon.
☞ If you are using a new tape cassette provided with a stopper, be sure to remove
the stopper before installing the cassette.
Make sure that the end of the tape feeds under the cassette tape guides.
4 Insert the tape cassette firmly into the tape compartment, making sure that the entire
back of the cassette touches the bottom of the compartment.
☞ When inserting the tape cassette, make sure that the inner ribbon does not catch
on the corner of the metal guide.
5 Attach the back cover by inserting the tab on the bottom end of the cover into the slot
on the bottom end of the machine, then pushing down firmly on the top end of the
cover until it snaps into place.
6 Turn on the machine if it is off, and then feed the tape to remove any slack by holding
down and pressing once.
7 Press in the tape cutter lever to cut off any excess tape.
Code
Feed
Sym.