2
INTRODUCTION AND SAFE OPERATION
The LS7 printer was designed specifically to make cable, patch panel, faceplate and facility
marking effortless. This palm-sized printer combines high quality thermal transfer print, fast
loading tape cassettes and industrial label materials to eliminate conc erns about labels falling
off.
This manual will guide you step by step through the set-up, operation, and troubleshooting of
the LS7 Printer. If you have problems not covered herein, contact your local Panduit Sales
Representative or call Panduit Technical Support at 866-871-4571 (outside the US, refer to
page 70 for contact information).
SAFE OPERATION PRACTICES
The following general safety practices supplement the specific warnings and cautions
depicted elsewhere in this manual. They are recommended precautions that must be
understood and applied during the operation and maintenance of this printer.
Do Not Operate In An Explosive Environment
Do not operate the printer in the presence of flammable gases or fumes. Operation of this
printer in such an environment constitutes a definite safety hazard.
Do Not Operate In Wet Or Damp Areas
Do not operate this printer in wet or damp areas. Operation of the printer in such an
environment constitutes a definite safety hazard.
Do Not Substitute Parts Or Modify Equipment
Because of the danger of introducing additional hazards, do not install substitute parts or
perform an unauthorized modification to the printer or its accessories. The proper
components for service and repair may be obtained from Panduit Corp.
WAR NI NG :
When the printer has been in use for an extended period of time, the printer motor may
become hot. DO NOT touch the printer motor with bare hands.
Patent numbers and patent publication numbers which are related to this product are as
follows: USP4839742, USP4927278, USP4976558, USP4983058, USP5009530,
USP5069557, USP5120147