Filter
Top Products
PANDUIT TDP4*HGMTDPH-MAN
Page 3-24
Section 3: Configuration
This selection allows the user to select the character set used by
the printer. The selections are English, French, German, Spanish,
Italian and Portuguese.
1. Press the LINE key to advance to the desired language setting.
2. When the setting is correct, press the FEED key to accept the
setting and step to the next display.
If the printer is placed in the Multi-Item Buffer Mode (DSW2-5 =
OFF), the user can chose to ignore CAN (18H) and DLE (10H)
commands used in bi-directional communications (see Section 6:
Interface Specifications). If the Single Item Buffer Mode is chosen
(DSW2-5 = ON), this display will be skipped.
SELECT LANGUAGE
ENGLISH
IGNORE CANDLE
YES NO
PRIORITY SETTING
COMMAND LCD
This selection allows the user to assign a priority for Print Darkens,
Print Speed and Print Offset setting methods. If LCD is selected, the
setting established via the LCD display/menu system will be used
for an incoming label job, regardless of any different command
settings. If Command is selected, any commands in the label job
will take precedence and be used for printing the job.
1. Use the LINE key to step to the desired priority.
Once the desired setting is selected, press the FEED key to accept
the setting and step to the next display.
LABEL RE-DETECT
ENABLE DISABLE
This selection allows the user to disable the feeding of a blank label
upon power up. If Enable is selected, the printer will automatically
feed a label until it detects a label edge. This will correctly position
the next printed label under the print head. If Disable is selected,
the printer will not try to detect the next label and the operator is
responsible for ensuring that the label is correctly positioned before
printing.
1. Use the LINE key to step to the desired setting.
Once the desired setting is selected, press the FEED key to accept
the setting and step to the next display.
If the printer is placed in the Single Item Buffer Mode (DSW2-5 =
ON), this selection allows the user to set the width of the IEEE1284
ACK pulse. In the Multi-Item Buffer Mode, this display will be
skipped.The range is 0.5 µsec to 10 µsec.
1. Use the LINE key to step the display to the desired setting. The
setting will advance in increments of 0.1 µsec each time the
LINE key is pressed until the setting reaches 10.0 µsec when it
will wrap around to the 0.5 µsec setting.
Once the desired setting is selected, press the FEED key to accept
the setting and step to the next display.
The Service mode is exited by powering the printer off and then
back on.
IEEE1284
ACK SIGNAL 00.5
SERVICE MODE