Panduit TDP42H Printer User Manual


 
Once the default operation is completed, a DEFAULT COMPLETED message will be displayed on the LCD
panel. The printer should be powered off while this message is being displayed (or after the beep is heard. This
saves the default settings in the non-volatile memory where they will be automatically loaded the next time the
printer is powered on.
PANDUIT TDP4*H GMTDPH-MAN
Page 3-7
Section 3: Configuration
Default Settings
SWITCH SELECTIONS
All switches are placed in the Off default position for shipping. This will result in the following operating
configuration:
Communications: 8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol: Ready/Busy
Sensor: Gap Sensor
Receive Buffer: Multi Job
Mode: Batch/continuous
Label Sensor: Sensor Used
Backfeed: Enabled
External Signals: Enabled
SOFTWARE DEFAULT SETTINGS
The printer stores the software settings upon receipt and uses them until they are again changed by receipt of a
command containing a new setting. These settings are stored in non-volatile memory and are not affected by
powering the printer off. The printer may be reset to use the default software settings by depressing the LINE
and FEED keys simultaneously while powering the printer on. This will result in the following default
configuration:
Print Darkness
Print Speed
Print Reference
Zero
Print Offset
Ignore CR/LF
Character Pitch
Ignore CAN/DLE
Auto On Line
Feed on Error
Feed Reprint
Priority
Language
CC1 Mem Select
Eurocode
3
TDP4*H
6 ips (3 ips for TDP46H)
Vertical = 0000, Horizontal = 0000
No Slash
+0
Disabled
Proportional
Disabled
Enabled
Enabled
Disabled
Command
English
Card
D5
H
DEFAULT COMPLETED