Filter
Top Products
PANDUIT TDP4*H GMTDPH-MAN
Page 2-3
Section 2: Installation
Setting Up the Printer
Consider the following when setting up the printer:
• Locate a solid flat surface with adequate room to set the printer. Make sure there is enough room at
the top and right-hand (facing the printer) side to provide clearance for the label access door to swing
open.
• The location should be near the host computer or terminal. The maximum distance for RS232 cables
is 35 feet and six feet for IEEE1284 Parallel cables. Cables can be purchased locally, and their
configuration will depend upon the host system being used. A IEEE1284 compliant cable must be used
to realize the full throughput potential of the printers.
NOTE: For information on interfacing the printer to a host system, see Section 5: Interface Specifications.
Verify that you have the following materials when unpacking:
• Printer
• Power Cord and Extra Ribbon Core
• Operator’s Manual
• CD-ROM
Printer
Operator Manual
Power Cord
CD-Rom
Ribbon Core