Filter
Top Products
AT Command Set and S-Registers
14-93810-A2-GB30-30 September 1998
Table 14-1
(7 of 12)
3800 Series AT Commands
AT
Command
Front Panel
Branch
Description
&I Dial Transmit Level
When Dial Transmit Level Type is set to Permissive, &In sets Dial Transmit
Level to a value between –10 and –32 dBm. &I99 and &I100 cause the level to
be varied automatically according to conditions for Enhanced Throughput
Cellular (ETC) operation, and are valid only if ETC is installed.
&I10 –10 dBm
&I11 –11 dBm
S S
S S
&I32 –32 dBm
&I99 Automatically adjusted according to the ETC1.0 specification. Use only
with remote modems set to &I99, and limit the data rate to 4800 bps
(S41 = 5). Set by &F6.
&I100 Automatically adjusted according to the ETC1.1 specification.
NOTE: &J0 overrides this command; &In overrides the &J0 command.
Configure\Edit\Dial Line
&Jn Dial Transmit Level Type
&J0 Permissive (Approx. –9 dBm).
NOTE: &Jn overrides the &In command.
Configure\Edit\Dial Line
&Ln Leased Mode
&L0 Disables leased-line operation.
&L1 2-wire originate leased-line operation.
&L2 4-wire originate leased-line operation (Model 3810 and 3811 only).
&L3 2-wire answer leased-line operation.
&L4 4-wire answer leased-line operation (Model 3810 and 3811 only).
The &L command will cause the modem to reset before entering or exiting
Leased-Line mode. Therefore, it must be entered as the last command in an
initialization string.
Configure\Edit\Leased
Line