Filter
Top Products
4. Configuration
4-4 July 2004 4821-A2-GN21-10
BitStorm 4800 Express Startup Procedure
You can initialize your BitStorm 4800 Express via a PC or terminal connected to
the unit’s CONSOLE port. Then, using a series of CLI commands, GrandVIEW
EMS or another Element Management System, or the web interface, you can
configure the unit according to your requirements.
Login
Procedure
To log in to the BitStorm 4800 Express:
1. Connect a PC or terminal to the CONSOLE port. (See Console Port in
Chapter 2, Cabling.)
2. At the login> prompt, type admin and press Enter.
3. At the password> prompt, press Enter. The default login password is blank.
4. At the PDYN> prompt, type privilege and press Enter.
5. At the password# prompt, press Enter. The default privileged password is
blank.
You are now logged on and in privileged mode, which allows you to configure the
unit.
Management Modes
The startup procedure for the BitStorm 4800 Express system differs depending on
the type of management used:
Inband Management – Operates over the uplink.
Out-of-Band Management – Operates over Port 1.