Paradyne 8312, 8314 Network Router User Manual


 
3. DSL Card Configuration
3-28
April 2001 8000-A2-GB26-50
ARP Table (Parameters and Add ARP Entry) A-E-F (A and B)
Select
Parameters (A)
or
ARP Entry (B)
Parameters (A)
Allows you to configure general Address Resolution Protocol (ARP) cache parameters.
Complete Entry Timeout (minutes)
Length of time that a complete entry remains in
the ARP Table before removal. A complete entry is one for which there is a MAC address
and a node has responded to the ARP request. Range = 1200,000 minutes (Default =
20).
Incomplete Entry Timeout (minutes)
Length of time in minutes that an incomplete
entry remains in the ARP table before being removed. (An incomplete entry is an entry
without a MAC address.) This is also the amount of time that a packet will remain in the
system while waiting for address resolution. Range = 1255 minutes (Default = 3).
NOTE: If you have made changes to this screen, you must do a card reset for the
changes to be in effect.
ARP Entry (Add ARP Entry) (B)
Allows you to add entries into the ARP cache.
Item
Enter 0 (zero) to add a new record.
IP Address
nnn.nnn.nnn.nnn
format.
MAC Address
xx-xx-xx-xx-xx-xx
format.
VNID
Enter a VNID ID between 24000 (Default = None). You must make an entry in
this field.
Trailer
Yes/No (Default = No).
Perm
Yes/No (Default = No). If you select Yes for Permanent and No for Proxy, the ARP
entry will be saved in NVRAM (up to 32 entries). These are loaded when the card resets.
Total
0Dynamic. (This field is read-only).
NOTE: For the Add ARP Entry (B) screen, all other information entered is not stored in
the non-volatile memory and will be lost when you reset the card.
Table 3-4. Bridge Options (5 of 5)