Filter
Top Products
Initial Setup Instructions
3-4
8000-A2-GB20-20
November 1997
Chassis Information Screen
"
Procedure
1. Choose Chassis Info from the HotWire Chassis Main Menu to enter or
display chassis configuration information.
The following table describes the information you should enter on the
Chassis Information screen. This information is used in the general section of
the SNMP MIB II.
Field
Input Description
Chassis Name 16 alphanumeric characters Name for the equipment
Chassis Contact 32 alphanumeric characters Name and phone number of
individual responsible for the
equipment
Chassis Location 16 alphanumeric characters Physical location of the
equipment
Bay Number 16 alphanumeric characters Floor and/or bay number of the
equipment
Chassis Number 16 alphanumeric characters Chassis serial number (located
on the lower right side of
chassis)
2. When you have made the appropriate changes to the screen, a message
Configuration has been modified. Save (yes/no)? appears.
Enter yes to save changes and press Return to go back to the HotWire
Chassis Main Menu.
What’s Next?
Now you are ready to configure your HotWire DSLAM. Refer to Chapter 4,
Configuring the HotWire DSLAM,
for instructions on how to configure the
mandatory minimum configurations, and Chapter 5,
MCC Card Configuration,
and Chapter 6,
DSL Card Configuration
, for additional configuration instructions
when customizing your application.
After you have configured your system, you can monitor and troubleshoot
potential problems on the system. Refer to Chapter 7,
Monitoring the HotWire
DSLAM
, and Chapter 8,
Diagnostics and Troubleshooting
, for more information.