Filter
Top Products
MCC Card Configuration
5-6
8000-A2-GB20-20
November 1997
Table 5-2. Interfaces Menu Options (2 of 2)
IP Network A-C-B
Gives the user the ability to configure up to 16 IP addresses for the LAN port. However,
under normal conditions, only one IP address in the management domain need be
assigned.
IP Interface – 15 characters. s1b = backplane that connects all cards; e1a = Ethernet
port.
Base IP Addr –
nnn.nnn.nnn.nnn
format.
Base Subnet Mask –
nnn.nnn.nnn.nnn
format.
IP Addr –
nnn.nnn.nnn.nnn
format. (You may enter up to 16 addresses.) Only appears if
e1a is the IP interface name.
Subnet Mask –
nnn.nnn.nnn.nnn
format. (You may enter up to 16 addresses.) Only
appears if e1a is the IP interface name.
Input Filter – Optional.
Output Filter – Optional.
Peer IP Address –
nnn.nnn.nnn.nnn
format. Only appears if s1b is the interface name.
Route to Peer – Net. Only appears if s1b is the interface name.
NOTE: If you have made any changes to this screen, you must do a card reset or
restart the appropriate interface (e1a or s1b). For changes to the s1b
interface, the peer IP address for each of the DSL ports (s1c, s1d, s1e, s1f)
on each DSL card must be changed and saved. In addition, the DSL card
must be reset.
Control (Control Interface) A-C-C
Gives the user the ability to restart, stop, and monitor (up, down, or testing) the current
state of an interface.
This screen is populated depending on your entry in the Command and Interface Name
fields. For example, if you select Monitor mode and enter s1b for the Interface name,
the following information is displayed: Type, State, Link Protocol, IP State, Uptime,
Inactive, Connect Time, Port, Local IP Addr, and Peer IP Addr.