Filter
Top Products
DSL Card Configuration
6-3
8000-A2-GB20-20
November 1997
Table 6-1. Card Status Options (2 of 4)
Time/Date A-A-C
Gives the user the ability to configure the local time and date on the DSL card with
network time and to synchronize the DSLAM’s clock via a Network Time Protocol (NTP)
server.
Local Time/Date – Enter the time in
hh.mm
format (am or pm). Enter the date in
mm/dd/yy
format.
Client NTP Mode – Broadcast/Unicast (Default = Broadcast). Select the Client Network
Time Protocol (NTP) Mode.
NTP Server –
nnn.nnn.nnn.nnn
format. Enter the NTP Server IP address.
Synchronized(hrs) – 1–24 (Default = 1). Enter the hours between synchronization.
NOTE: At system boot time, the time on the DSL cards automatically synchronizes
with the MCC card. Therefore it is usually not necessary to use this screen
on the DSL card.
NVRAM Clear Screen (Clear NVRAM) A-A-D
Gives the user the ability to clear out the Non-Volatile RAM (NVRAM) in order to reuse
the card or to reconfigure the current card.
CAUTION: If you select yes on this screen, you will permanently remove most of
the configuration information you have stored on this card and all IP
addresses and routing tables will have to be re-entered. The system will
perform a reset and return to the factory configuration.