Filter
Top Products
10
Interconnecting 8610 Systems
" Procedure
To interconnect multiple 8610 systems:
1. Connect the end of an 8-pin modular cable into the Management OUT port of the
base chassis.
2. Dress the 8-pin modular cable to the left and under the chassis, behind the foot,
and up the side of the unit.
3. Plug the other end of the 8-pin modular cable into the Management IN port of the
8610 chassis above, dressing the cable as in the previous step.
4. Repeat for the next 8610 chassis, connecting the Management OUT port of
Chassis 2 to the Management IN port of Chassis 3.
NOTE:
Bus cables must use Unshielded Twisted Pair (UTP) CAT5 cable. The total bus
cabling should not exceed 25 feet.